3Com 8807 Command Reference Manual page 102

100 C 7: IP A
HAPTER DDRESS
C C
ONFIGURATION OMMANDS
Parameter
interface-type interface-number: interface-type refers to the interface type, and
interface-number refers to the interface number. Refer to the interface command
in Port Command Manual for more information.
Description
Use the display ip interface command to display information about an interface.
Example
# Display the information about interface VLAN-interface 1.
<SW8800> display ip interface vlan-interface 1
Vlan-interface1 current state : DOWN
Line protocol current state : DOWN
Internet Address is 1.1.1.1/8 Primary
Broadcast address : 1.255.255.255
The Maximum Transmit Unit : 1500 bytes
input packets : 0, bytes : 0, multicasts : 0
output packets : 0, bytes : 0, multicasts : 0
TTL invalid packet number:
ICMP packet input number:
Echo reply:
Unreachable:
Source quench:
Routing redirect:
Echo request:
Router advert:
Router solicit:
Time exceed:
IP header bad:
Timestamp request:
Timestamp reply:
Information request:
Information reply:
Netmask request:
Netmask reply:
Unknown type:
DHCP packet deal mode:
Table 11 Description on the fields of the display ip interface command
Field
Vlan-interface1 current state
Line protocol current state
Internet Address
Broadcast address
The Maximum Transmit Unit
input packets : 0, bytes : 0, multicasts : 0
output packets : 0, bytes : 0, multicasts : 0
TTL invalid packet number
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
global
Description
Current state of the VLAN interface 1
Current state of the Line protocol
IP address
Broadcast address
Maximum transmission unit
The number of the input/output unicast
packets, bytes and broadcast packets are all 0
The number of the received packets with
invalid TTLs