Network - 3Com 8807 Command Reference Manual

Hide thumbs Also See for 8807:

Table of Contents

ONFIGURATION

By default, RIP does not import any other route.

The import-route command is used to import the route of another protocol by

using a certain cost value. RIP regards the imported route as its own route and

transmits it with the specified cost value. This command can greatly enhance the

RIP capability of obtaining routes, thus increasing the RIP performance.

If the cost value is not specified, routes will be imported according to the default

cost ranging from 1 to 16. If the cost value of the imported route is 16, then RIP

continues to advertise this cost to other routers running RIP, and marks this route

"Hold Down". However, this router can still forward packets until the Garbage

Collection timer times out (defaults to 120 seconds).

Related command: default cost.

# Import a static route with the cost value of 4.

[3Com-rip] import-route static cost 4

# Set the default cost and import an OSPF route with the default cost.

[3Com-rip] default cost 3

[3Com-rip] import-route ospf

network

network network-address

undo network network-address

network-address: IP address of the RIP interface. It can be the IP network address

of any interface.

Use the network command to enable Routing Information Protocol (RIP) for the

specified network connected to the router.

Use the undo network command to disable the RIP on the interface.

By default, all RIP interfaces are disabled.

RIP route processes are disabled on all interfaces by default. To enable a RIP route

process on an interface, use the network command.

The undo network command is similar to the undo rip work command in terms

of function. But they are not identical. Their similarity is that the interface using

either command will not receive/transmit RIP routes. The difference between them

is that, in the case of undo rip work, other interfaces will still forward the routes

of the interface using the undo rip work command. In the case of undo

Show Quick Links

Table of Contents