Igmp Enable - 3Com 8807 Command Reference Manual

<SW8800> display igmp interface
Vlan-interface1 (10.153.17.99):
IGMP is enabled
Current IGMP version is 2
Value of query interval for IGMP(in seconds): 60
Value of other querier time out for IGMP(in seconds): 120
Value of maximum query response time for IGMP(in seconds): 10
Value of robust count for IGMP: 2
Value of startup query interval for IGMP(in seconds): 15
Value of last member query interval for IGMP(in seconds): 1
Value of query timeout for IGMP version 1(in seconds): 400
Policy to accept IGMP reports: none
Querier for IGMP: 10.153.17.99 (this router)
IGMP group limit is 1024
No IGMP group reported
Table 86 Description on the fields of the display igmp interface command
Field
IGMP version
query interval
querier timeout
max query response time
robust count
startup query interval
last member query interval
query timeout
Policy to accept IGMP reports Filter policy for the IGMP multicast group to control the
Querier for IGMP
IGMP group limit

igmp enable

Syntax
igmp enable
undo igmp enable
View
VLAN interface view
Parameter
None
Description
Use the igmp enable command to enable IGMP on an interface.
Use the undo igmp enable command to disable IGMP on the interface.
IGMP Configuration Commands
Description
IGMP version
General query interval
Querier timeout time
Maximum query response time
IGMP robust count, namely the number of times IGMP querier
sends IGMP specific group query packet when it receives an
IGMP Leave packet from a host
Startup query interval
The interval at which the IGMP querier sends IGMP specific
group query packets when it receives an IGMP leave packet
from a host
Query timeout for IGMP V1
accesses to the IP multicast group
IGMP querier
Quantity limit of IGMP groups added to the interface. After the
limit is reached, the router does not process the IGMP join
messages
605