Display Startup; Display This - 3Com 8807 Command Reference Manual

72 C 3: C F M C
HAPTER ONFIGURATION ILE ANAGEMENT OMMANDS

display this

Syntax
display this
View
Any view
Parameter
None
Description
Use the display this command to display the running configuration of the current
view. If you need to authenticate whether the configurations is correct after you
have finished a set of configurations under a view, you can use the display this
command to view the running parameters.
Some effective parameters are not displayed if they are the same with the default
ones, while some parameters, though have been configured by the user, if their
related functions are not effective, are not displayed either. For example, if X.25 is
encapsulated at the data link layer on an interface, you can configure PPP
parameter on the interface, but cannot view the configuration information when
executing the display this command.
Associated configuration of the interface is displayed when executing the
command in different interface views; related configuration of the protocol view is
displayed when executing this command in different protocol views; and all the
configuration of the protocol view is displayed when executing this command in
protocol sub-views.
Related command: save, reset saved-configuration, display
current-configuration, display saved-configuration.
Example
# Display the running configuration parameters for the current view of the switch
system.
<SW8800> display this

display startup

Syntax
display startup
View
Any view
Parameter
None
Description
Use the display startup command to display the related system software and
configuration filenames used for the current and the next start-ups.
This command is used to display the following information: the filename of the
system software for the current enabling configured by the user, the filename of