Reset Igmp Group - 3Com 8807 Command Reference Manual

IGMP Configuration Commands 615
Description
Use the igmp version command to specify the version of IGMP that a router uses.
Use the undo igmp version command to restore the default value.
The system does not automatic switching between different IGMP versions.
Therefore, all routers on a subnet must be configured to run the same IGMP
version.
Example
# Run IGMP Version 1 on VLAN-interface10.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800]interface vlan-interface 10
[3Com-Vlan-interface10] igmp version 1

reset igmp group

Syntax
reset igmp group { all | interface vlan-interface interface-number { all |
group-address [ group-mask ] } }
View
User view
Parameter
all: All IGMP groups.
interface vlan-interface interface-number: VLAN virtual interface type and
number.
group-address: IGMP group address.
group-mask: Segment mask of the IGMP group address.
Description
Use the reset igmp group command to delete an existing IGMP group from the
interface. The deleted group can added again on the interface.
Example
# Delete all IGMP groups on all the interfaces.
<SW8800> reset igmp group all
# Delete all IGMP groups on the Vlan-intrface10.
<SW8800> reset igmp group interface Vlan-interface10 all
# Delete the group 225.0.0.1 from the Vlan-interface10.
<SW8800> reset igmp group interface Vlan-interface10 225.0.0.1
# Delete the IGMP groups ranging from 225.1.1.0 to 225.1.1.255 on the
Vlan-interface10.