Dot1X Max-User - 3Com 8807 Command Reference Manual

802.1x Configuration Commands 299
provide the interface-list argument, Guest VLAN is enabled on the ports specified
by this argument.
If you execute the dot1x guest-vlan command in Ethernet interface view, this
command does not accept the interface-list argument and Guest VLAN is enabled
only on the current port.
Example
# Specify to perform port-based authentications.
[SW8800] dot1x port-method portbased
# Enable Guest VLAN on all ports.
[SW8800] dot1x guest-vlan 1

dot1x max-user

Syntax
dot1x max-user user-number [ interface interface-list ]
undo dot1x max-user [ interface interface-list ]
View
System view, Ethernet port view
Parameter
user-number: Specifies the limit to the amount of supplicants on the port, ranging
from 1 to 1024.
By default, the maximum user number is 1024. And a switch can accommodate a
total of 2048 users.
interface interface-list: Ethernet interface list expressed in the format interface-list
=interface-type interface-number [ to interface-type interface-number ] &<1-10>.
interface-type means the interface type, interface-number is the interface number.
Refer to command parameters in the "Port" section in the manual for the
respective meanings and value ranges of them. The interface number after the key
word to should be no smaller than the interface number before to. &<1-10> in
the command means that the preceding parameter can be entered up to 10 times.
Description
Use the dot1x max-user command to configure a limit to the amount of
supplicants on the specified interface of 802.1x.
Use the undo dot1x max-user command to restore the default value.
This command is used for setting a limit to the amount of supplicants that 802.1x
can hold on the specified interface. This command has effect on the interface
specified by the parameter interface-list when executed in system view. It has
effect on all the interfaces when no interface is specified. The parameter
interface-list cannot be input when the command is executed in Ethernet interface
view and it has effect only on the current interface.
Related command: display dot1x.