Stp Pathcost-Standard; Stp Point-To-Point - 3Com 8807 Command Reference Manual

198 C 13: MSTP C C
HAPTER ONFIGURATION OMMANDS
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] interface GigabitEthernet3/1/1
[3Com-GigabitEthernet3/1/1]stp disable
[SW8800] stp non-flooding slot 3
# Discard BPDU packets received on all ports when STP is not globally enabled.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] stp disable
[SW8800] stp non-flooding

stp pathcost-standard

Syntax
stp pathcost-standard { dot1t | dot1d-1998 | legacy }
View
System view
Parameter
dot1t, dot1d-1998, legacy : Three standards of the path cost calculation on STP
port.
Description
Use the stp pathcost-standard command to set the path cost calculation
standard on STP port.
The port rate must be obtained first before you can calculate the path cost of a
port as the path cost is associated with the port rate. The three standards use their
own way to work out the port rate, based on which each standard calculates the
port path cost by a certain algorithm.
By default, the legacy standard is applied for the switch Switch 8800 Family.
Example
# Set the DOT1D-1998 as the path cost calculation standard on the STP port.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] stp pathcost-standard dot1d-1998

stp point-to-point

Syntax
stp point-to-point { force-true | force-false | auto }
undo stp point-to-point
View
Ethernet port view
Parameter
force-true: Indicates the Ethernet port connected to a point-to-point link.
force-false: Indicates the Ethernet port not connected to a point-to-point link.