Portal Method - 3Com 8807 Command Reference Manual

The ReDHCP authentication method requires that the IP address of an
■
authentication-free user and the master IP address of the interface belong to
the same network section. The Direct authentication method requires that the
IP address of an authentication-free user and that of the VLAN interface belong
to the same network section.
This configuration takes effect after Portal is enabled in the VLAN that the
■
authentication-free users belongs to.
The Layer 3 Portal authentication method does not support the
■
authentication-free user configuration.
Example
# Configure authentication-free users for the Portal authentication.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] portal free-user mac 00e0-fc01-0101 ip 10.110.1.1 vlan 10 i
nterface ethernet 2/1/1

portal method

Syntax
portal method { direct | layer3 | redhcp }
undo portal method
View
System view
Parameter
direct: Adopts the direct authentication method in Portal authentication.
layer3: Adopts the layer 3 Portal authentication method, namely, accoss-layer-3
Portal authentication method in authentication.
redhcp: Adopts the ReDHCP authentication method in Portal authentication.
Description
Use the portal method command to set the running method of Portal
authentication.
Use the undo portal method command to restore the default running method of
Portal authentication.
The direct authentication method is adopted in Portal authentication by default.
Example
# Set to adopt the ReDHCP method in Portal authentication.
<SW8800>system-view
System View: return to User View with Ctrl+Z.
[SW8800] portal method redhcp
Portal Configuration Commands 377