3Com 8807 Command Reference Manual page 320

318 C 21: AAA RADIUS/HWTACACS P C C
HAPTER AND ROTOCOL ONFIGURATION OMMANDS
the user nor the RADIUS server, the user will adopt the Idle-cut state in the
template.
Because a user template only works in one ISP domain, it is necessary to configure
user template attributes for users from different ISP domain respectively.
Related command: domain.
Example
# Enable the user in the current ISP domain, 3com163.net, to use the Idle-cut
attribute specified in the user template (that is, enabling the user to use the
Idle-cut function). The maximum idle time is 50 minutes and the minimum data
traffic is 500 bytes.
[3Com-isp-3com163.net] idle-cut enable 50 500
ip pool Syntax
ip pool pool-number low-ip-address [ high-ip-address ]
undo ip pool pool-number
View
System view, ISP domain view
Parameter
pool-number: Address pool number ranging from 0 to 99.
low-ip-address and high-ip-address: Two ends of the IP address pool. The number
of IP addresses in an address pool cannot exceed 1024. If you do not provide the
high-ip-address argument, then the address pool only contains the one specified
by the low-ip-address argument.
Description
Use the ip pool command to create a local IP address pool for PPP users.
Use the undo ip pool command to remove a specified local address pool.
By default, no local IP address pool is created.
After creating an IP address pool in system view, you can use the remote address
command to assign IP addresses in it to PPP users.
The IP addresses in an IP address pool created in ISP domain view are mainly for
PPP users of the ISP domain. This kind of IP address pools is suitable for ports with
many PPP users connected to them and the available IP address these ports
provide are not sufficient. For example, a PPPoE-enabled Ethernet port can
accommodate up to 4095 users, but its Virtual Template can have only one IP
address pool configured, which contains up to only 1024 IP address. By
configuring an ISP domain address pool for the Ethernet port, PPP users of the ISP
can obtain their IP addresses from the IP address pool, through which the tension
of the port address pool can be eased.
Related command: remote address.