Mac-Address Max-Mac-Count - 3Com 8807 Command Reference Manual

MAC Address Table Management Commands 163
For detailed description on interface-type and interface-number see Port
Configuration section of this manual.
vlan-id: Specifies the VLAN ID.
Description
Use the mac-address command to add/modify the MAC address table entry.
Use the undo mac-address command to cancel the MAC address table entry
If the input address has been existed in the address table, the original entry will be
modified. That is, replace the interface pointed by this address with the new
interface and the entry attribute with the new attribute (dynamic entry, static entry
and permanent entry).
All the (MAC unicast) addresses on a certain interface can be deleted. User can
choose to delete any of the following addresses: address learned by system
automatically, dynamic address configured by user, static and permanent
addresses configured by user.
Related command: display mac-address.
Example
# Configure the port number corresponding to the MAC address 00e0-fc01-0101
as Ethernet2/1/1 in the address table, and sets this entry as static entry.
<SW8800> system-view
System View: return to User View with Ctrl+Z.
[SW8800] mac-address static 00e0-fc01-0101 interface ethernet 2/1/1 vlan 2
mac-address Syntax
max-mac-count
mac-address max-mac-count count
undo mac-address max-mac-count
View
Ethernet port view
Parameter
count: Maximum number of MAC addresses learned by a port, ranging from 0 to
14,336, the value of 0 means that address learning is disabled.
Description
Use the mac-address max-mac-count command to set the maximum number of
MAC addresses learned by an Ethernet port.
Use the undo mac-address max-mac-count command to remove the limit on
the maximum number of MAC addresses learned by an Ethernet port.
By default, a port can learn as many MAC addresses as on an I/O Module. You can
change the default value by using this command: if you set the value to count,
and when the number of MAC addresses learned by the port reaches this value,