Apply grease to the movable drive face position
sensor shaft.
– Gear tooth: 0.50 – 0.70 g (0.018 – 0.025 oz)
– Journal: 0.10 – 0.20 g (0.004 – 0.007 oz)
Install the sensor shaft as shown.
Before installing the
sensor shaft, check
Install the sensor plate aligning the bolt holes and
the sensor plate
make sure that the sensor shaft direction is within
groove.
the tolerance as shown in the illustration.
If the sensor shaft direction can not be within the
tolerance, turn the shaft 180° and reinstall it.
Apply oil to a new O-ring and install it into the sen-
sor plate groove.
Install the sensor plate.
Install the movable drive face position sensor (page
24-52).
Perform the Honda S Matic System initial setting
procedure (page 24-61).
maxiscooter-club.ru
Honda S Matic System (NSS250A)
JOURNAL
GEAR TOOTH
SENSOR SHAFT
Align
TOLERANCE
SHAFT
O-RING
SENSOR PLATE
TOLERANCE
SENSOR SHAFT
24-59