Honda NSS250S Manual page 491

Hide thumbs Also See for NSS250S:

Table of Contents

Install the snap ring into the groove in the master

Install the snap ring

with its chamfered

edge facing the

thrust load side.

Snap ring pliers

• Check that the snap ring is seated in the groove.

• Do not reuse the snap ring which could easily

spin in the groove.

Install the piston boot into the master cylinder and

groove in the piston.

Apply silicone grease to the master piston tip-to-

brake lever contacting area.

Instal the brake light/inhibitor switch and tighten the

screws to the specified torque.

TORQUE: 1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)

Fill the contact surfaces with 0.10 g (0.004 oz) mini-

mum of silicone grease of the brake lever, piston tip

and brake lever pivot bolt sliding surface.

Install the brake lever.

Install the pivot bolt and tighten it to the specified

TORQUE: 1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)

Install the pivot nut and tighten it to the specified

TORQUE: 6 N·m (0.6 kgf·m, 4.4 lbf·ft)

maxiscooter-club.ru

07914-SA50001

HYDRAULIC BRAKE

BRAKE LIGHT/INHIBITOR SWITCH

SNAP RING PLIERS

Chapters

Table of Contents