DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
Remove the O-rings and oil seals from the movable
driven pulley face.
DRIVEN FACE BEARING REPLACEMENT
Remove the needle bearing using special tools.
TOOLS:
Bearing remover set, 25 mm
Remover weight
Remove the snap ring and ball bearing.
Pack new ball bearing cavities with grease.
Install the ball bearing into the driven face squarely
with the sealed side facing down until it is fully
seated.
TOOLS:
Driver
Pilot, 28 mm
11-30
maxiscooter-club.ru
07936-ZV10100
07741-0010201
07749-0010000
07746-0041100
OIL SEALS
O-RINGS
REMOVER WEIGHT
SNAP RING
BEARING
DRIVER/PILOT
BEARING
NEEDLE BEARING