Honda NSS250S Manual page 514

ABS (NSS250A)
3. Indicator Operation Inspection
Connect the combination meter 28P (Gray) con-
nector (page 22-10).
Turn the ignition switch ON, engine stop switch
to " ".
With the combination meter 28P connector con-
nected, short the Red/black wire terminal of the
combination meter and ground with a jumper
wire.
CONNECTION: Red/black – Ground
Check the ABS indicator with the ignition switch
turned ON.
Does the ABS indicator go off?
YES
NO
4. Indicator Signal Line Open Circuit Inspection
Remove the jumper wire from the combination
meter 28P (Gray) connector.
Disconnect the ABS modulator 25P connector
(page 18-28).
With the combination meter 28P (Gray) connec-
tor connected, short the Red/black wire terminal
of the ABS modulator 25P connector and ground
with a jumper wire.
TOOL:
Test probe
CONNECTION: Red/black – Ground
Check the ABS indicator with the ignition switch
turned ON.
Does the ABS indicator go off?
YES
NO
18-14
maxiscooter-club.ru
– GO TO STEP 4.
– Faulty combination meter
07ZAJ-RDJA110
– Fauly ABS modulator
– Open circuit in Red/black wire between
the combination meter and ABS modu-
lator.
28P CONNECTOR
COMBINATION METER 28P CONNECTOR
Red/black
25P CONNECTOR
(Wire side/female terminal)
Red/black