Honda NSS250S Manual page 232

FUEL SYSTEM (PGM-FI)
INSTALLATION
• When installing the fuel pump unit, put the mat-
ing surface of the fuel tank on a level surface.
Clean the mating surface of the fuel tank and fuel
pump unit.
Apply oil to the lip surface of a new packing inside.
Place a new packing onto the fuel tank.
Always replace the
packing with a new
• Be careful not to pinch the dirt and debris
one.
between the fuel pump and packing.
Install the fuel pump unit with the fuel pump joint
facing to left.
• Be careful not to damage the fuel level sensor
when installing the fuel pump unit.
Install the set plate to the fuel pump unit by aligning
the holes and tabs.
• Be careful not to damage the pipe end when
installing the set plate.
Install the set plate and fuel pump unit mounting
nuts.
Tighten the fuel pump unit mounting nuts to the
specified torque in the specified sequence as
shown.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Install the fuel tank (page 6-80).
6-78
maxiscooter-club.ru
FUEL PUMP
FUEL PUMP UNIT
NUTS
1
3
5
FUEL PUMP UNIT
Align
PACKING
FUEL PUMP JOINT
SET PLATE
4
2