Honda NSS250S Manual page 355

Hold the drive pulley face using a special tool and
install the drive face bolt.
Tighten the drive face bolt to the specified torque.
TOOL:
Universal holder
TORQUE: 83 N·m (8.5 kgf·m, 61 lbf·ft)
Install the ratio control gear holder (page 24-54).
Install the left crankcase cover (page 11-9).
Perform the Honda S Matic System initial setting
procedure (page 24-61).
CLUTCH/DRIVEN PULLEY
REMOVAL
Remove the left crankcase cover (page 11-7).
Remove the drive pulley face.
– NSS250S: (page 11-11)
– NSS250A: (page 11-18)
Hold the clutch outer with a special tool and loosen
the clutch outer nut.
TOOL:
Flywheel holder
Remove the special tool and nut.
Remove the collar and clutch outer.
Remove the clutch/driven pulley assembly.
Remove the drive belt from the driven pulley.
maxiscooter-club.ru
07725-0030000
07725-0040001
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
BOLT/WASHER
NUT
COLLAR
CLUTCH/DRIVEN PULLEY ASSEMBLY
DRIVE BELT
UNIVERSAL HOLDER
FLYWHEEL HOLDER
CLUTCH OUTER
11-27