DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
DRIVE PULLEY (NSS250A)
REMOVAL
Remove the left crankcase cover (page 11-7).
Remove the ratio control gear holder (page 24-54).
Hold the drive pulley face with special tool and
loosen the drive face bolt.
TOOL:
Universal holder
Remove the bolt, washer and collar.
Remove the drive pulley face.
Remove the drive belt and drive pulley face boss A.
When the drive belt
is replaced, perform
the Honda S Matic
System initial
setting procedure
(page 24-61).
Remove the reduction gear B and movable drive
pulley assembly together.
11-18
maxiscooter-club.ru
07725-0030000
BOLT
WASHER
UNIVERSAL HOLDER
DRIVE PULLEY FACE
DRIVE BELT
BOSS A
REDUCTION GEAR B
MOVABLE DRIVE PULLEY ASSEMBLY
COLLAR