FUEL SYSTEM (PGM-FI)
4. Make sure the connection is secure and that the
locking pawls are firmly locked into place; check
visually and by pulling the connector.
5. Make sure the rubber cap is in place (between
the retainer tabs).
6. Increase the fuel pressure and check that there is
no leakage in fuel supply system (page 6-75).
INJECTOR SIDE
1. Insert a new retainer into the connector.
• Align new retainer locking pawls with the con-
nector grooves.
2. Set the joint rubber to the injector joint as
shown.
3. Install the connector to the injector joint.
Then press the quick connect fitting onto the
injector joint until both retainer pawls lock with a
"CLICK".
If it is hard to connect, put a small amount of
engine oil on the injector joint end.
4. Make sure the connection is secure and that the
locking pawls are firmly locked into place; check
visually and by pulling the connector.
5. Make sure the joint rubber is in place (between
the retainer tabs).
6. Increase the fuel pressure and check that there is
no leakage in fuel supply system (page 6-75).
6-74
maxiscooter-club.ru
RUBBER CAP
LOCKING PAWLS
Align
CONNECTOR
JOINT RUBBER
LOCKING PAWLS
RETAINER
INJECTOR JOINT
JOINT RUBBER