Ratio Control Motor - Honda NSS250S Manual

Honda S Matic System (NSS250A)
Remove the movable drive face position sensor and
O-ring.
INSTALLATION
Apply oil to a new O-ring and install it.
Install the movable drive face position sensor by
aligning the sensor shaft flat surfaces with the posi-
tion sensor grooves as shown.
Turn the movable drive face position sensor and
align the bolt holes.
Install the bolts and tighten them to the specified
torque.
TORQUE: 3.5 N·m (0.4 kgf·m, 2.6 lbf·ft)
Connect the movable drive face position sensor 3P
(Black) connector.
Perform the Honda S Matic System initial setting
procedure (page 24-61).
Install the left crankcase cover (page 11-9).

RATIO CONTROL MOTOR

REMOVAL
Remove the luggage lower box (page 3-16).
Turn the ignition switch OFF.
Disconnect the ratio control motor 2P (Black) con-
nector.
24-52
maxiscooter-club.ru
POSITION SENSOR
O-RING
Align
POSITION SENSOR
Align
3P CONNECTOR
2P CONNECTOR
O-RING
BOLTS