Honda NSS250S Manual page 428

FRONT WHEEL/SUSPENSION/STEERING
Set the right master cylinder by aligning the end of
the master cylinder with the punch mark on the han-
dlebar.
Set the holder with the "UP" mark facing up and
tighten the upper bolt first, then tighten the lower
bolt to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the front brake light switch connectors.
Bind the right handlebar switch wire with the wire
band.
Install the right rearview mirror and tighten the lock
The right rearview
nut to the specified torque.
mirror lock nut has
left-hand threads.
TORQUE:
Rearview mirror adaptor bolt:
26 N·m (2.7 kgf·m, 19 lbf·ft)
Rearview mirror lock nut:
26 N·m (2.7 kgf·m, 19 lbf·ft)
When removing the handlebar weight, install the
handlebar weight.
Install a new screw and tighten it securely.
Install the left handlebar switch housing by aligning
the locating pin of the switch housing with the hole
on the handlebar.
15-10
maxiscooter-club.ru
RIGHT MASTER CYLINDER
CONNECTORS
"UP" MARK
WIRE BAND RIGHT REARVIEW MIRROR
LEFT HANDLEBAR WEIGHT
SCREW
Align
LEFT HANDLEBAR SWITCH HOUSING
PUNCH MARK
HOLDER
BOLTS