ALTERNATOR/STARTER CLUTCH
RIGHT CRANKCASE COVER
REMOVAL
Drain the coolant (page 7-7).
Drain the engine oil (page 4-11).
Remove the following:
– Right body cover (page 3-11)
– Right floor skirt (page 3-9)
– Muffler (page 3-32)
Disconnect the following:
– Alternator 3P (Black) connector
– CKP sensor 2P (Red) connector
Unhook the alternator/CKP sensor wire from the
clamp.
Remove the bolt and rear brake hose joint.
Remove the bolt and parking brake cable clamp.
Remove the clip and disconnect the water hose
from the water pump cover.
Loosen the hose band screw and disconnect the
water hose from the water pump cover.
Remove the bolt/washers and raise and hold the
rear of the air cleaner housing.
13-4
maxiscooter-club.ru
NSS250A shown:
2P (Red) CONNECTOR
3P (Black) CONNECTOR
BOLTS
HOSE JOINT
CLIP
HOSE BAND SCREW
AIR CLEANER HOUSING
CLAMP
CABLE CLAMP
WATER HOSES
BOLT/WASHERS