Honda NSS250S Manual page 661

maxiscooter-club.ru
7. Movable Drive Face Position Sensor Installation
Inspection
Remove the movable drive face position sensor
(page 24-51).
Check that the slot of the movable drive face
position sensor and sensor shaft are aligned.
Is the position sensor installed correctly?
YES – GO TO STEP 8.
NO – Install the position sensor correctly,
then GO TO STEP 9.
8. Movable Drive Face Position And Movable Drive
Face Gear Train Inspection
Remove the drive pulley face (page 11-18).
Check the movable drive face position shaft turn
smoothly by turning the movable drive face gear
with your hand.
Does the movable drive face position shaft turn
smoothly?
YES – GO TO STEP 9.
NO – Ratio control motor and sensor shaft
not synchronized with the program.
Inspect the following:
• Reduction gear B (page 24-54)
• Movable drive face position sensor
shaft (page 24-54)
• Each bearing (page 24-56)
• Movable drive
(page 11-18)
9. Movable Drive Face Position Sensor Resistance
Inspection 1
Measure the resistance at the movable drive face
position sensor 3P connector of the sensor side.
CONNECTION: A – B
B – C
A – C
STANDARD: 0 – 6.0 kΩ (20°C/68°F)
Is the resistance within 0 – 6.0 k Ω (20 ° C/68 ° F)?
YES – GO TO STEP 10.
NO – Faulty movable drive face position sen-
sor
Honda S Matic System (NSS250A)
MOVABLE DRIVE
PULLEY ASSEMBLY
pulley assembly
3P CONNECTOR
(Sensor side/male terminals)
Align
SENSOR SHAFT
B
B
A
C
A C
24-17