ALTERNATOR/STARTER CLUTCH
Degrease the taper of the flywheel.
Install the flywheel to the crankshaft by aligning its
groove with the woodruff key of the crankshaft.
Apply oil to the flywheel bolt threads and seating
surface.
Install the washer and flywheel bolt.
Hold the flywheel with a special tool and tighten the
flywheel bolt to the specified torque.
TOOL:
Flywheel holder
TORQUE: 103 N·m (10.5 kgf·m, 76 lbf·ft)
Clean the starter driven gear guide bolt threads.
Apply locking agent to the bolt threads (coating
width 6.5 ± 1.0 mm (0.26 ± 0.04 in) from the tip of
exclude 2.0 – 3.0 mm (0.08 – 0.12 in)).
Install the starter driven gear guide and bolt.
Tighten the bolt securely.
Install the right crankcase cover (page 13-5).
13-14
maxiscooter-club.ru
07725-0040001
Align
FLYWHEEL
BOLT/WASHER
FLYWHEEL HOLDER
BOLT
DRIVEN GEAR GUIDE