Honda NSS250S Manual page 241

Remove the bolts, stay and injector/joint assembly
from the intake pipe.
Remove the injector from the injector joint, O-ring
and seal ring.
INSTALLATION
Coat a new O-ring and new seal ring with engine oil.
Install the O-ring and seal ring, being careful not to
Replace the O-ring
damage.
and seal ring with
new ones as a set.
Install the injector into the injector joint, being care-
ful not to damage the O-ring by aligning the lug of
the injector joint with the connector of the injector
as shown.
maxiscooter-club.ru
FUEL SYSTEM (PGM-FI)
BOLTS
INJECTOR/JOINT ASSEMBLY
INJECTOR
SEAL RING
INJECTOR
SEAL RING
INJECTOR Align
INJECTOR JOINT
STAY
INJECTOR JOINT
O-RING
INJECTOR JOINT
O-RING
6-87