Movable Drive Face Position; Sensor - Honda NSS250S Manual

MOVABLE DRIVE FACE POSITION

SENSOR

INSPECTION
• Movable drive face position sensor malfunction
("F" 29 blinks) can be detected after starting the
engine.
• When removing the movable drive face position
sensor, perform the Honda S Matic System initial
setting procedure (page 24-61).
Remove the left crankcase cover (page 11-7).
Turn the ignition switch OFF.
Disconnect the movable drive face position sensor
3P (Black) connector.
Turn the ignition switch ON and engine stop switch
" ".
Measure the voltage between the movable drive
face position sensor 3P connector of the wire side.
CONNECTION:
Yellow/black (+) – Green/orange (–)
STANDARD: 4.75 – 5.25 V
If there are no voltage, check for open or short cir-
cuit in Yellow/black wire and open circuit in Green/
orange wire.
Remove the movable drive face position sensor
(page 24-54).
Measure the resistance at the position sensor 3P
connector terminals.
CONNECTION: A – B
STANDARD:
Make sure the resistance changes when turning the
sensor shaft groove.
If the measurement is out of specification, replace
the movable drive face position sensor.
Install the left crankcase cover (page 11-9).
REMOVAL
Remove the left crankcase cover (page 11-7).
Turn the ignition switch OFF.
Disconnect the movable drive face position sensor
3P (Black) connector.
Remove the bolts.
maxiscooter-club.ru
0 – 6.0 kΩ (20°C/68°F)
Honda S Matic System (NSS250A)
3P CONNECTOR
(Wire side/female terminals)
Green/
orange
3P CONNECTOR
3P CONNECTOR
(Sensor side/male terminals)
POSITION SENSOR
BOLTS
3P CONNECTOR
Yellow/
black
24-51