Honda NSS250S Manual page 363

Install the clutch side plate and secure it with the E-
clips.
CLUTCH/DRIVEN PULLEY ASSEMBLY
Assemble the following:
– Driven pulley assembly
– Spring guide collar
– Spring seat
– Driven pulley face spring
– Seal collar
– Clutch assembly
Set the clutch/driven pulley assembly onto the spe-
To prevent loss of
cial tool by aligning the bosses with the holes in the
tension, do not
clutch.
compress the
clutch spring more
TOOL:
than necessary.
Clutch spring compressor
Hold the spring compressor in a vice.
Install the clutch/driven pulley nut.
Tighten the clutch/driven pulley nut using a special
tool to the specified torque.
TOOL:
Socket wrench, 39 x 41 mm
TORQUE: 79 N·m (8.1 kgf·m, 58 lbf·ft)
Remove the clutch/driven pulley assembly from the
special tool.
maxiscooter-club.ru
07LME-GZ40201
07GMA-KS40100
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
E-CLIPS
DRIVEN PULLEY ASSEMBLY
SPRING GUIDE
COLLAR
SPRING
CLUTCH/DRIVEN PULLEY ASSEMBLY
CLUTCH SPRING COMPRESSOR
CLUTCH/DRIVEN PULLEY ASSEMBLY
DRIVEN PULLEY NUT
SIDE PLATE
SPRING SEAT
SEAL COLLAR
CLUTCH ASSEMBLY
11-35