Honda NSS250S Manual page 226

FUEL SYSTEM (PGM-FI)
5. To prevent damage and keep foreign matter out,
cover the disconnected connector and pipe end
with the plastic bags.
INJECTOR SIDE
1. Relieve the fuel pressure (page 6-71).
2. Check the fuel quick connect fitting for dirt, and
clean if necessary.
Place a shop towel over the quick connect fitting.
3. Remove the connector damper as shown.
4. Hold the connector with one hand and squeeze
the retainer tabs with the other hand to release
them from the locking pawls.
Pull the connector off, then remove the retainer
from the injector joint.
• Absorb the remaining fuel in the fuel feed hose
from flowing out with a shop towel.
• Be careful not to damage the hose or other parts.
• Do not use tools.
• If the connector does not move, keep the retainer
tabs pressed down, and alternately pull and push
the connector unit it comes off easily.
6-72
maxiscooter-club.ru
PLASTIC BAG
CONNECTOR
QUICK CONNECT FITTING
CONNECTOR DAMPER
RETAINER TABS
LOCKING PAWLS
PIPE
CONNECTOR