Honda NSS250S Manual page 352

DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
Install the drive pulley face boss B.
Coat a new oil seal with oil and install it to the mov-
Be careful not to
able drive pulley face.
get the lubricant on
the movable drive
Coat a new O-ring with oil and install it to the stop-
pulley face.
per arm.
Install the stopper arm and socket bolts.
Tighten the socket bolts to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Apply molybdenum disulfide paste to the movable
drive pulley dust seal lips and install it to the screw
gear as shown.
Fill the screw gear threads with 4.0 – 5.0 g (0.14 –
0.18 oz) of the molybdenum disulfide paste and
install it to the movable drive pulley face assembly.
Install the stopper plate to the stopper arm and
socket bolts.
Tighten the socket bolts to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
11-24
maxiscooter-club.ru
OIL SEAL
BOSS B
SOCKET BOLTS
STOPPER ARM
TAB
DUST SEAL
SCREW GEAR
STOPPER PLATE SOCKET BOLT
STOPPER ARM
O-RING
DUST SEAL
STOPPER ARM