Led Holder; Rf Unit - Honda NSS250S Manual

Honda Smart Card Key System

LED HOLDER

INSPECTION
Turn the ignition switch OFF.
Remove the inner cover (page 3-27).
Install the LF antenna (page 23-30).
Disconnect the LED holder 3P (Black) connector.
Measure the voltage between the LED holder 3P
connector of the wire side and ground.
CONNECTION: Red/white (+) – Ground (–)
There is continuity if the system is normal.
Measure the voltage at the LED holder 3P connector
of the wire side.
CONNECTION: Red/white (+) – Red/black (–)
There should be battery voltage when the ignition
switch is pushed.

RF UNIT

INSPECTION
Remove the fuse/relay box (page 3-17).
Disconnect the RF unit 5P (Green) connector.
23-28
maxiscooter-club.ru
Red/white (+) – Yellow/black (–)
3P CONNECTOR
LED HOLDER 3P CONNECTOR
(Wire side/female terminals)
Red/white
Yellow/black
Red/
black
LED HOLDER 3P CONNECTOR
(Wire side/female terminals)
Red/white
White/red
5P CONNECTOR