Honda NSS250S Manual page 319

CYLINDER HEAD COVER INSTALLATION
Check that the rubber seal is in good condition,
replace it if necessary.
Install the rubber seal to the groove of the cylinder
head cover.
Apply liquid sealant (Three Bond 1211 or equiva-
lent) to the cylinder head cover semi-circular cut-out
as shown.
Install the cylinder head cover to the cylinder head.
Install the rubber washers to the cylinder head
The "UP" mark of
cover.
the rubber washer
facing the bolt
head.
maxiscooter-club.ru
CYLINDER HEAD/VALVES
RUBBER SEAL
CYLINDER HEAD COVER
RUBBER SEAL
"UP" MARK
9-25