Honda NSS250S Manual page 248

FUEL SYSTEM (PGM-FI)
3. Ground Line Inspection
Turn the ignition switch OFF.
Check the continuity between the bank angle
sensor 3P (Black) connector of wire side and
ground.
CONNECTION: Green/orange – Ground
Is there continuity?
YES
NO
REMOVAL/INSTALLATION
Remove the screen garnish (page 3-18).
Disconnect the bank angle sensor 3P (Black) con-
nector and remove the connector clamp.
Remove the screws and bank angle sensor.
Install the bank angle sensor with its "UP" mark fac-
Route the sensor
ing up and back.
wire correctly (page
Tighten the mounting screws to the specified
1-21).
torque.
TORQUE: 1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)
Connect the bank angle sensor 3P (Black) connector.
Install the screen garnish (page 3-18).
6-94
maxiscooter-club.ru
– Faulty bank angle sensor
– Open circuit in Green/orange wire
BANK ANGLE SENSOR 3P CONNECTOR
(Wire side/female terminals)
Green/orange
SCREWS CONNECTOR CLAMP
3P (Black) CONNECTOR
BANK ANGLE SENSOR
UP MARK