HYDRAULIC BRAKE
Hold the rear caliper pin and remove the rear caliper
Do not reuse the
bolt.
rear caliper bolt.
• Be careful not to damage the caliper pin boot.
Remove the brake pads.
Clean the inside of the caliper especially around the
caliper piston.
Install new pads so that their ends are set in the pad
Always replace the
retainers on the caliper bracket properly.
brake pads in pairs
to ensure even disc
pressure.
Hold the rear caliper pin and install the new rear cal-
iper bolt to the specified torque.
TORQUE: 22 N·m (2.2 kgf·m, 16 lbf·ft)
• Be careful not to damage the caliper pin boot.
Install the caliper to the swingarm so that the disc is
positioned between the pads, being careful not to
damage the pads.
Install new brake caliper mounting bolts and tighten
them to the specified torque.
TORQUE: 30 N·m (3.1 kgf·m, 22 lbf·ft)
Operate the left brake lever to seat the caliper piston
against the pads.
Install the muffler (page 3-32).
17-16
maxiscooter-club.ru
CALIPER BOLT
CALIPER PIN
BRAKE PADS
CALIPER BOLT
CALIPER PIN
MOUNTING BOLT
BOOT
Align
BOOT
CALIPER