Honda NSS250S Manual page 237

Hide thumbs Also See for NSS250S:

Table of Contents

DISASSEMBLY/ASSEMBLY

• The throttle body is factory pre-set. Do not disas-

semble in a way other than shown in this man-

• Do not snap the throttle valve from full open to

full close after the throttle cable has been

removed. It may cause incorrect idle operation.

• Do not damage the throttle body. It may cause

incorrect throttle valve.

• Do not loosen or tighten the white painted bolt

and nut of the throttle body. Loosening or tight-

ening them can cause throttle valve and idle con-

trol failure.

• When removing the sensor unit, perform the

throttle valve fully closed reset procedure (page

Remove the following:

– Sensor unit (page 6-88)

– IACV (page 6-103)

Blow open all air passages and sensor holes in the

Cleaning the air

throttle body with compressed air.

passages and

sensor hole with a

piece of wire will

damage the throttle

3.4 N·m (0.3 kgf·m, 2.5 lbf·ft)

Assembly is in the reverse order of disassembly.

– IACV (page 6-103)

– Sensor unit (page 6-88)

maxiscooter-club.ru

FUEL SYSTEM (PGM-FI)

WHITE PAINTED

Chapters

Table of Contents