Apply silicone grease to a new pad pin stopper ring
outer surface.
Install the pad pin by pushing the pads against the
pad spring to align the pad pin holes in the pads
and caliper.
Tighten the pad pin to the specified torque.
TORQUE: 17 N·m (1.7 kgf·m, 13 lbf·ft)
Operate the right/left brake lever to seat the caliper
pistons against the pads.
REAR
Remove the muffler (page 3-32).
Push the caliper piston all the way in by pushing the
Check the fluid level
caliper body inward to allow installation of new
in the master
brake pads.
cylinder reservoir as
this operation
causes the fluid
level to rise.
Remove the rear caliper mounting bolts and rear
brake caliper from the swingarm.
maxiscooter-club.ru
HYDRAULIC BRAKE
NSS250A shown:
BRAKE PADS
NSS250A shown:
BRAKE PADS
MOUNTING BOLTS
STOPPER RING
PAD PIN
PAD PIN
CALIPER
17-15