Honda NSS250S Manual page 663

maxiscooter-club.ru
13. Movable Drive Face Position Sensor Signal Line
Short Circuit Inspection
Check the continuity between the movable drive
face position sensor 3P connector of the wire
side and ground.
CONNECTION: Yellow/blue – Ground
Is there continuity?
YES – Short circuit in Yellow/blue wire
NO – GO TO STEP 14.
14. Failure Reproduction
Install the following:
– Movable drive face position sensor (page 24-
58)
– Ratio control motor (page 24-53)
Erase the DTC's from the PCM (page 24-10).
Perform the Honda S Matic System initial setting
procedure (page 24-61).
Test-ride the scooter then retrieve the problem
code (page 24-8).
Is DTC 5-1 indicated?
YES – Replace the PCM with a known good
one, and recheck.
NO – Intermittent failure
Honda S Matic System (NSS250A)
3P CONNECTOR
(Wire side/female terminals)
Yellow/blue
METER DISPLAY
(GEAR POSITION INDICATOR)
24-19