Honda NSS250S Manual page 435

Drive new left bearing (brake disc side) squarely
until it is fully seated, using special tools.
TOOLS:
Driver
Attachment, 42 x 47 mm
Pilot, 20 mm
Install the distance collar.
Drive new right bearing squarely until it is fully
seated, using special tools.
Apply grease to a new dust seal lips.
Install the dust seal into right side of the wheel hub
until it is flush with the wheel hub.
Apply grease to a new dust seal lips.
Do not get grease
Install the dust seal into right side of the wheel hub
on the brake disc or
until it is flush with the wheel hub.
stopping power will
be reduced.
Install the brake disc on the wheel hub with the
stamp facing out.
Install and tighten new front brake disc socket bolts
to the specified torque.
TORQUE: 42 N·m (4.3 kgf·m, 31 lbf·ft)
Install the front pulsar ring (page 18-25).
NSS250A:
INSTALLATION
Install the side collars to both side of the front
wheel.
maxiscooter-club.ru
07749-0010000
07746-0010300
07746-0040500
FRONT WHEEL/SUSPENSION/STEERING
ATTACHMENT/PILOT
DUST SEAL
STAMP
DUST SEAL
SOCKET BOLTS
NSS250A shown:
SIDE COLLARS
DRIVER
BEARING
BRAKE DISC
15-17