Honda NSS250S Manual page 427

maxiscooter-club.ru
Install the handlebar into the right handlebar switch
housing/throttle grip.
Install the handlebar onto the lower holders align-
ing the punch mark on the handlebar with the top
edge of the lower holder.
Install the upper holders with the punch marks fac-
ing forward.
Install the socket bolts and tighten the front side
socket bolts first, and then tighten the rear side
socket bolts to the specified torque.
TORQUE: 27 N·m (2.8 kgf·m, 20 lbf·ft)
Align the locating pin of the right handlebar switch
housing with the hole on the handlebar.
Install the screws and tighten the forward screw
first, then the rear screw.
Install the right handlebar weight.
Install a new screw and tighten it.
FRONT WHEEL/SUSPENSION/STEERING
SOCKET BOLTS
UPPER HOLDERS PUNCH MARK
RIGHT HANDLE SWITCH
NSS250A shown:
SWITCH HOUSING
RIGHT HANDLEBAR WEIGHT
HANDLEBAR
CAPS
Align
SCREWS
SCREW
15-9