maxiscooter-club.ru
FUEL SYSTEM (PGM-FI)
INSTALLATION
Install a new O-ring to the throttle body groove
If the O-ring is not
SENSOR UNIT
O-RING
properly.
installed properly,
the idle air will leaks
Install the sensor unit to the throttle body by align-
and engine idle
ing the clip of the TP sensor and boss of the throttle
speed will be
drum.
unstable.
Align
Install the torx screws and tighten them to the spec-
ified torque.
TORQUE: 3.4 N·m (0.3 kgf·m, 2.5 lbf·ft)
TORX SCREWS
Connect the sensor unit 5P (Black) connector.
5P (Black) CONNECTOR
Install the luggage lower box (page 3-16).
• Perform the throttle valve fully closed reset pro-
cedure (page 6-90).
6-89