Honda NSS250S Manual page 387

Install the parking brake cable clamp and rear brake
hose joint to the stay and install the bolts.
Tighten the bolts securely.
Hook the alternator/CKP sensor wire to the clamp.
Connect the following:
– Alternator 3P (Black) connector
– CKP sensor 2P (Red) connector
Install the following:
– Muffler (page 3-33)
– Right floor skirt (page 3-9)
– Right body cover (page 3-11)
Fill the crankcase with oil (page 4-11).
Fill and bleed the cooling system (page 7-6).
ALTERNATOR STATOR/CKP SENSOR
REMOVAL
Remove the right crankcase cover (page 13-4).
Remove the wire band and release the alternator/
CKP sensor wire.
Remove the following:
– Bolts, stator
– Wire grommet
– Bolts, CKP sensor
maxiscooter-club.ru
ALTERNATOR/STARTER CLUTCH
BOLTS
HOSE JOINT
NSS250A shown: 2P (Red) CONNECTOR
3P (Black) CONNECTOR
WIRE BAND
WIRE
WIRE GROMMET
CKP SENSOR
CABLE CLAMP
CLAMP
BOLTS
STATOR
BOLTS
13-7