Honda NSS250S Manual page 490

Hide thumbs Also See for NSS250S:

Table of Contents

HYDRAULIC BRAKE

NSS250A shown:

1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)

BRAKE LIGHT/

INHIBITOR SWITCH

1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)

• Keep the piston, cups, spring, snap ring and boot

as a set; do not replace the parts individually.

• Be sure that each parts is free from the dust or

dirt before reassembly.

Coat the master piston outer surface, piston cup

whole surface and master cylinder inner surface

with clean DOT 4 brake fluid.

Install the spring onto the master piston.

Install the spring to the master piston end.

Install the spring and master piston into the master

Do not allow the

piston cup lips to

turn inside out.

maxiscooter-club.ru

MASTER PISTON

6 N·m (0.6 kgf·m, 4.4 lbf·ft)

1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)

Chapters

Table of Contents