Honda NSS250S Manual page 455

REAR WHEEL/SWINGARM
REMOVAL
Remove the muffler (page 3-32).
Support the scooter securely on its center stand.
Apply parking brake and loosen the rear axle nut,
then unlock the parking brake.
Remove the mounting bolts and rear brake caliper
Do not operate the
from the swingarm.
brake lever after
removing the brake
caliper.
• Support the brake caliper so that it does not hang
from the brake hose. Do not twist the brake hose.
• Do not reuse the mounting bolts.
Remove the bolt/washers.
Lift the rear end of the air cleaner housing and hold
it.
Remove the bolt and parking brake cable clamp.
Remove the following:
– Adjusting nut
– Joint pin
– Parking brake cable (from the swingarm)
maxiscooter-club.ru
REAR WHEEL/PARKING BRAKE/SUSPENSION
REAR AXLE NUT
REAR BRAKE CALIPER
CALIPER BOLTS
AIR CLEANER HOUSING
BOLT/WASHERS
ADJUSTING NUT CLAMP
JOINT PIN PARKING BRAKE CABLE
BOLT
16-5