Honda NSS250S Manual page 477

Connect a bleed hose to the upper bleed valve and
bleed the system as follows:
1. Pump the right brake lever several (5 – 10) times,
then squeeze the right brake lever all the way
and loosen the bleed valve 1/4 of a turn. Wait
several seconds and then close the bleed valve.
• Do not release the brake lever until the bleed
valve has been closed.
2. Release the right brake lever slowly until the
breed valve has been closed.
3. Repeat the steps 1 and 2 until there are no air
bubbles in the bleed hose.
Tighten the bleed valve to the specified torque.
TORQUE: 5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
After bleeding air completely fill the reservoir with
DOT 4 brake fluid to the upper level.
Install the diaphragm, diaphragm plate, reservoir
cap and tighten the screws securely.
TORQUE: 1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)
LEFT (COMBINED) BRAKE LINE FILLING/AIR
BLEEDING
BRAKE FLUID FILLING:
Connect a commercially available brake bleeder to
the lower bleed valve of the front brake caliper.
• Follow the manufacturer's operating instruc-
tions.
Connect a commercially available brake bleeder to
If an automatic refill
the front brake caliper lower bleed valve.
system is not used,
add fluid when the
Loosen the rear brake caliper bleed valve and per-
fluid level in the
form the bleeding procedure until the system is
reservoir is low.
completely flushed/bled.
Tighten the rear brake caliper bleed valve to the
specified torque.
TORQUE: 5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
maxiscooter-club.ru
HYDRAULIC BRAKE
FRONT UPPER
BLEED VALVE
SCREWS
DIAPHRAGM PLATE
BLEED VALVE
BRAKE BLEEDER
RESERVOIR CAP
DIAPHRAGM
17-11