Honda NSS250S Manual page 385

maxiscooter-club.ru
Loosen the bolts in a crisscross pattern in two or
three steps and remove the bolts and right crank-
case cover.
Remove the water joint collar and O-ring.
Remove the oil joint collar and O-ring.
Remove the gasket and dowel pins.
INSTALLATION
Clean the mating surfaces of the right crankcase
cover and right crankcase.
Apply oil to a new O-ring and install it to the oil joint
collar.
Install a new O-ring to the water joint collar.
Install the water joint collar and oil joint collar.
Install the dowel pins and a new gasket to the crank-
case.
Align the oil pump driven sprocket bolt groove with
the index mark of the driven sprocket cover.
Align the tabs of the right crankcase cover and
water pump shaft as shown.
ALTERNATOR/STARTER CLUTCH
BOLTS RIGHT CRANKCASE COVER
DOWEL PINS OIL JOINT COLLAR/O-RING
GASKET WATER JOINT COLLAR/O-RING
DOWEL PINS OIL JOINT COLLAR/O-RING
GASKET WATER JOINT COLLAR/O-RING
Align DRIVEN SPROCKET
Align
SPROCKET COVER PUMP SHAFT
13-5