Honda NSS250S Manual page 353

Coat a new O-ring with oil and install it to the screw
gear.
Install the screw gear holder and socket bolts.
Tighten the socket bolts to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Coat a new O-ring with oil and install it to the mov-
able drive pulley face assembly.
Apply 2.5 – 3.5 g (0.09 – 0.12 oz) of the molybdenum
disulfide paste to the movable drive face spline col-
lar teeth.
Install the spline collar to the movable drive pulley
face assembly.
INSTALLATION
Hold the slide pieces of the stopper arm and turn
Movable drive
the movable drive pulley face with your hand until
pulley face is in the
the screw gear tab contact with the stopper arm tab.
most squeezed
position when the
tabs contact each
other.
maxiscooter-club.ru
DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
DUST SEAL
SOCKET BOLTS
SCREW HOLDER
SPLINE COLLAR
OIL SEAL
Contact
ENGINE
SIDE
MOVABLE DRIVE FACE
11-25