Renault Laguna III Manual page 3248

Rear floor rear cross member: General description
K91
Note:
The information contained in the following
describes the general repair procedure for all vehi-
cles having the same design for this part.
Before reading this general information, check that
there are no special notes associated with this vehi-
cle. These special notes will be specified if applica-
ble in other parts of this subsection dealing with the
part.
DESIGN OF THE STRUCTURAL COMPONENT
Note:
For a detailed description of a particular connec-
tion, see MR 400.
This serves as a rear floor rear cross member, it con-
sists of an assembly of several parts that can be un-
clipped from the new part depending on the
requirements of the impact concerned.
WARNING
If the mating faces of the parts to be welded are not
accessible, make EGW plug welds to replace the
original resistance welds (see MR 400).
REAR LOWER STRUCTURE
122752
41D-11
41D