Renault Laguna III Manual page 3218

Sill panel: General description
Note:
The information contained in the following
describes the general repair procedure for all vehi-
cles having the same design for this part.
Before reading this general information, check that
there are no special notes associated with this vehi-
cle. These special notes are specified if necessary
in other parts of the sub-section dealing with the
component.
Note:
For a detailed description of a particular connec-
tion, (see MR 400).
I - DESIGN OF THE STRUCTURAL COMPONENT
This part is removed by cutting into the complete body
side. This part fulfils the basic function of the sill panel.
It can be replaced partially by following the cuts de-
scribed as follows.
SIDE LOWER STRUCTURE
122757
II - AREA TO BE CUT FOR COMPLETE
REPLACEMENT
The lines (1) , (2) and (3) mark the cutting areas for the
complete replacement of the sill panel.
III - AREA TO BE CUT FOR PARTIAL
REPLACEMENT
The lines (1) and (4) mark the areas for the partial re-
placement of the front of the sill panel.
41C-1
41C
110580
110582