Renault Laguna III Manual page 3253

FRONT UPPER STRUCTURE
Front wing: General description
B91 or D91 or K91
Note:
The information contained in the following
describes the general repair procedure for all vehi-
cles having the same design for this part.
Before reading the following general information,
make sure that there are no special notes associ-
ated with the vehicle. These special notes are spec-
ified if necessary in other parts of the sub-section
dealing with the component.
I - DESIGN OF THE STRUCTURAL COMPONENT
This is a basic part; it is made of steel and is bolted
onto its upper mounting support.
II - REMOVAL - REFITTING
Note:
In all cases of removal of a component without its
replacement with a new one, mark the position of
the mountings before removing the mountings to
avoid adjustments during refitting.
To remove or replace the front wing, remove:
- the front wheel arch liner,
- the front bumper,
- the headlight,
- the windscreen lower trim piece.
III - ADJUSTMENT
Note:
The front wing is the penultimate removable compo-
nent to be fitted to the vehicle body in the factory.
For final adjustment, correctly position all the other
components including the bumper and the head-
lights for them to be correctly positioned.
Two main areas of adjustment may be identified:
- the adjustment of the rear area,
- the adjustment of the front area
1 - Adjustment of the rear area:
122759
42A-1
42A
122064