Renault Laguna III Manual page 3285

FRONT UPPER STRUCTURE
Bulkhead: General description
Note:
The information contained in the following
describes the general repair procedure for all vehi-
cles having the same design for this part.
Before reading this general information, check that
there are no special notes associated with this vehi-
cle. These special notes will be specified if applica-
ble in other parts of this subsection dealing with the
part.
Note:
For a detailed description of a particular connec-
tion, see MR 400.
I - DESIGN OF THE STRUCTURAL COMPONENT
This part contributes to the function of the bulkhead
and the pedal mounting plate.
The other parts that make up the bulkhead are:
- The bulkhead lower cross member
- The rear section of the wheel arches.
This is a removable part fixed by nuts and bonded by a
"windscreen adhesive" type cement bead. For prod-
ucts and tools required for removal and refitting of this
part, (see Windscreen: Removal - Refitting)
II - AREA TO BE CUT FOR PARTIAL
REPLACEMENT
Cutting line (1) shows the area in which it is possible to
carry out a partial replacement.
III - ASSEMBLY INSTRUCTIONS FOR A PARTIAL
REPLACEMENT
124589
42A-33
42A
131064