Network - Dell Z9500 Command Reference Manual

network

Enable RIP for a specified network. To enable RIP on all networks connected to the switch, use this
command.
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameters
ip-address
Defaults No RIP network is configured.
Command ROUTER RIP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
pre- 6.2.1.1
Usage
You can enable an unlimited number of RIP networks.
Information
RIP operates over interfaces configured with any address the network command
specifies.
Routing Information Protocol (RIP)
Specify an IP network address in dotted decimal format. You
cannot specify a subnet.
Description
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1547