Hello-Time - Dell Z9500 Command Reference Manual

Related

hello-time

Commands
max-age
configuration information.
hello-time
Set the time interval between the generation of the RSTP bridge protocol data units (BPDUs).
Z9500
Syntax
hello-time [milli-second] seconds
To return to the default value, use the no hello-time command.
Parameters
seconds
milli-second
Defaults 2 seconds
Command CONFIGURATION RSTP (conf-rstp)
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
7.6.1.0
7.5.1.0
6.2.1.1
1582
— changes the time interval between BPDUs.
— changes the wait time before RSTP refreshes the protocol
Enter a number as the time interval between transmission of
BPDUs. The range is from 1 to 10 seconds. The default is 2
seconds.
Enter the keywords milli-second to configure a hello time
on the order of milliseconds. The range is from 50 to 950
milliseconds
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the milli-second option to the S-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Rapid Spanning Tree Protocol (RSTP)